Nm-engineering NM1275A Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für das Auto Nm-engineering NM1275A herunter. NM Engineering NM1275A User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 1
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
!
NM Engineering 3300 Corte Malpaso, Camarillo, CA 93012 805.388.7171 805.388.0030 FAX
engineer@nm-eng.com www.nm-eng.com
!
Gauze-Type Air Filter Cleaning Instructions
Interval cleaning recommendations: Normally 10-12K miles or sooner for dirty and dusty
environments.
1. Remove filter. Lightly tap filter on surface to remove large debris.
2. Apply cleaner. FOLLOW ALL SAFETY INSTRUCTIONS ON THE AIR FILTER
CLEANER BOTTLE. Spray Air Filter Cleaner onto both sides of the air filter until it
completely saturates the pleated material. Allow cleaner to soak into air filter for 10
minutes to loosen the dirt. Do not let cleaner dry on air filter.
3. Rinse off air filter with cool low-pressure water. Allow gravity to flush dirt out of air filter
by applying water to the inside of the filter; up and down the length of the pleats.
Continue to rinse the filter until all traces of cleaner are gone. If the filter is extremely
dirty it may be necessary to repeat steps 2 and 3.
4. After rinsing, gently shake off excess water and allow filter to dry naturally. Do not oil
until the filter is completely dry. NOTE: DO NOT USE COMPRESSED AIR, DRYER
HEATERS OR HEAT GUNS TO SPEED UP THE DRYING PROCESS.
5. Apply air filter oil to the outside of the filter only. Using the aerosol spray can, spray an
even amount of oil along the crown of each pleat. Wait 20 minutes for the oil to be
absorbed into the filter media. Touch-up any area with oil until there is an even blue
color over the entire surface of the clean filter. Do not over oil. Once blue tint is clearly
visible on pleats, move on to another section. It is better to under oil than over. Over
soaked filter reduces performance significantly.
6. Clean filter’s inside mounting surface with degreaser such as Windex or 409. Do not
spray solution directly onto surface. Damp cleaning cloth with degreaser and wipe off
grease.
7. Reinstall filter.
Seitenansicht 0
1

Inhaltsverzeichnis

Seite 1

!NM Engineering ∞ 3300 Corte Malpaso, Camarillo, CA 93012 ∞ 805.388.7171 ∞ 805.388.0030 FAX [email protected] ∞ www.nm-eng.com ! Gauze-Type Air Fi

Kommentare zu diesen Handbüchern

Keine Kommentare